The Vacuum Bagging Film is widely used in Advance Composites Industries. This film is used to cover and seal the mould surface under vacuum condition in the process called Vacuum Infusion. This film is widely used due to is excellent physical properties such as high temperature resistance, toughness, good flexibility, high elongation and very less permeability.
Features:
l Normally colour is green heat stabilized and material is nylon
l It has excellent elongation and heat ageing characteristics capable of performing under high pressures and temperatures of up to 190°C for several hours
l A Caprolactam level of less than 1% makes it an ideal choice for most vacuum bagging applications
l It can be made available in different forms eg: lay flat or slit tube and in sheet form
Specification:
Parameters | Physical Parameters-55 Microns | Physical Parameters-65 Microns | Physical Parameters-75 Microns |
Material | PA-PE-PA | PA-PE-PA | PA-PE-PA |
Film Thickness | 55 Microns | 65 Microns | 75 Microns |
Film Colour | Transparent Green | Transparent Green | Transparent Green |
Resin Compatability | Styrene + Epoxy | Styrene + Epoxy | Styrene + Epoxy |
Standard Width (Lay Flat) | 600MM, 800MM,1200MM, 2000MM, 4000MM | 600MM, 800MM,1200MM, 2000MM, 4000MM | 600MM, 800MM,1200MM, 2000MM, 4000MM |
Working Temperature | Maximum Upto 180°C | Maximum Upto 180°C | Maximum Upto 180°C |
Storage & Handling | |||
Packing | The roll will be wrapped in polyethylene/bubble sheet over and above covered with hard card board case for protecting it from piercing or damaging from the pointed or hard material. | ||
Handling | Roll has to be handled properly having taken care roll doesn't get damanged or pierced. | ||
Storage | Has to be stored in the place where the sharp edges are not there.Has to be stored at room temperature and low moisture level place. |
*Note:Wide range of film can be undertaken for development based on the customer requirement where the application is at different temperature and for different purpose.